Multiboard Street Deck Refill 2 Sets With Mold
Designed to supplement our deck builder kits, this Veneer Refill kit will keep you building more and more boards.
Note: Pressing a Multiboard requires a 20x70" Thin Air Press bag. The Multiboard Kit will NOT fit in the 14x47" bag that comes with our preshaped sets.
Multiboard Street Deck Refill 2 Sets and Mold:
- 7-layers of Canadian maple per board
- each set includes 5 pre-engraved template sheets (9 possible shapes), and 2 cross grain sheets
- 3-dimensionally shaped foam mold
- illustrated instructions
Use this Refill Kit with the Builder Kit or TAP bag you already have, as an additional supply of veneer.
Note: A 20x70" (or larger) Thin Air Press bag is required for building a Multiboard.
The foam mold, Thin Air Press Bag and pump, edging tool and breather netting are designed to be used for many, many builds.
Keep all your reusable kit parts in good working order by following the maintenance tips included with the kit.
Store unused veneer in a stable environment, away from any heat sources. Protect it from extreme humidity, or lack of it, by wrapping in plastic. Lay veneer flat to prevent warping.
Q: As this kit doesn’t include glue, where do I get it?
A: Glue is available from this website, or locally if you can source Titebond III.
Q: What else do I need to make a board?
A: If you don’t already have these parts in your complete kit, a glue roller, a rasp, and sandpaper. Then a final coat of water-based, water-proof, exterior clear Varathane is recommended.
Q: Can I change the template shapes?
A: You can easily use the template shapes as a base and make changes to customize it to your liking. The pre-engraved template lines can be sanded away or easily covered with graphics or grip tape.
Q: What do I do if my veneer breaks or splits?
A: Veneer is fragile until laminated, and it is common to split or snap (especially the cross grains). A stripe of glue and some masking tape to hold it until it dries will fix broken or split sheets. See video (link)
Q: What else do I need to complete this project?
A: If you choose to set your boards up for riding, select grip tape at our checkout. Or shop locally for your grip, hardware (wheels, trucks and bearings). Use the guide holes on the bottom side to drill the truck holes through, using a 3/16” drill bit. And of course, don’t forget to wear your helmet!