Street Deck Refill 5 sets Veneer
Designed to supplement our deck builder kits, the Veneer Refill kits will keep you building more and more boards.
Select the correct width:
Original 32"L x 7 7/8"W OR the NEW 32"L x 8 1/2"W
Or try building a different shape (Old School, Pintail or Lil'Rockit) with a Veneer and Mold Refill Kit.
These 4 shapes of boards can all be pressed in the 14 x 47” Thin Air Press or larger.
Design and paint your own graphics, or select pre-printed graphic sheets (7 7/8" width only).
Street Deck Refill 5 Sets Veneer:
- 7-layers of Canadian maple per board
- includes 2 face, 3 long grain core and 2 cross grain sheets
- illustrated instructions
Use this Refill Kit with the Builder Kit or TAP bag you already have, as an additional supply of veneer.
Watch this customer-made video on building a Roarockit Kit
The foam mold, Thin Air Press Bag and pump, edging tool and breather netting are designed to be used for many, many builds.
Keep all your reusable kit parts in good working order by following the maintenance tips included with the kit.
Store unused veneer in a stable environment, away from any heat sources. Protect it from extreme humidity, or lack of it, by wrapping in plastic. Lay veneer flat to prevent warping.
Q: As this kit doesn’t include glue, where do I get it?
A: Glue is available from this website, or locally if you can source Titebond III.
Q: What else do I need to make a board?
A: If you don’t already have these parts in your complete kit, a glue roller, a rasp, and sandpaper. Then a final coat of water-based, water-proof, exterior clear Varathane is recommended.
Q: What do I do if my veneer breaks or splits?
A: Veneer is fragile until laminated, and it is common to split or snap (especially the cross grains). A stripe of glue and some masking tape to hold it until it dries will fix broken or split sheets. See video (link)
Q: What else do I need to complete this project?
A: If you choose to set your boards up for riding, select grip tape at our checkout. Or shop locally for your grip, hardware (wheels, trucks and bearings). Use the guide holes on the bottom side to drill the truck holes through, using a 3/16” drill bit. And of course, don’t forget to wear your helmet!
Q: Can I add a color sheet to my order?
A: Yes you can, however as those sheets come as uncut rectangles, you will need to trim that to shape before pressing.